Stock OEM (expensive, hard to find), the many fiberglass reproductions created (cheaper, but some don’t fit well), or the well known unit (made in the USA) by Spoolfool Productions (seems a bit pricey, however, fit is excellent & it’s basically a bolt on & your done item, no mods needed).
The latter is the one we opted for, especially since it has top quality fit & finish (better than the OEM factory fillers) and no painting is required for it (well, assuming that your car is black)!
.
Looking to acquire these front bumper fillers for your turbo buick?
.
Time to install: less than 1 hour.
.
How to:[NOTE: it may be easier to remove the front bumper, but not necessary if you’re careful]
1. remove head light bezels. (4 screws)
3. remove the 8 nuts that hold the old filler on (4 on the sides that attach to the fender, & 4 across the top).
4. pre-fit the new front bumper filler, check alignment, slot any holes if necessary, make adjustments.
5. secure it down.6. reinstall bezels.
8. enjoy these awesome looking pieces!
.
[TIP: the video has a bunch of tips & tricks for lining the filler up!]
.
.
Here’s a video SpoolFool made for installing the front bumper fillers:
.